View source for Example 3 (Over 90 Degree Bends)

This thread will show some example of making under 90 degree bends. If you haven't gone through the general rules of 3D, then do so: http://www.2020softwaresolutions.com...hread.php?t=48


ex 3.1 Lets start by making an closed "L" bracket.

1) Select the '''"1"''' from the '''"bend"''' selection list.

2) Enter a value of''' "12"''' to the '''front'''.

'''NOTE: The tri-star is located at the location where you are currently at. You are entering in the direction(s) and distance(s) from this point to your first bend.'''

[[File:Ex3.1.jpg|700px]]


3) Select the '''"End"''' from the '''"bend"''' selection list.

4) Enter a value of '''"10"''' to the''' left'''.

5) & Enter a value of '''"10"''' to the '''back'''.

'''NOTE: Again the tri-star is your current location and you are entering in the directions(s) and distance(s) from this point.'''

[[File:Ex3.2.jpg|700px]]