View source for My Material or Tooling Library won't Update

My material or die library won't update.

This is a common question and here is a list as to the reasons why:

--> You must select the '''"Add New"''' button before entering the tooling or material information.

*When you enter in the material diameter or wall thickness, or the achieved clr, calibrated clr or bend location offset you '''MUST''' use a decimal place number.
*No other characters such as symbols or abbreviations. Also do not use text like inches or mms.
*The material diameter must be greater than twice the wall thickness. Many times a user will put in .95 instead of .095
*In the material library the dimension under the '''circle''' is the OD of material. 

--> It is okay to leave the weight in the material library as 0.

--> When finished select the '''"Apply"''' button. This will update the list on the left hand side.

--> After you select the '''"Apply"''' button, the '''"OK"''' button is used to update the list to the hard drive. '''SELECT THE "OK" BUTTON WHEN FINISHED.'''