View source for XYZ Example 2 (Under 90 Degree Bend)

In this example, we will show you how to create an open "L" bracket.

'''NOTE: All XYZ locations are based upon a 0,0,0 global location. Which means that each location is referenced to an absolute location. The start point does NOT need to be 0,0,0.'''

While in the XYZ interface:

1) Zero out the '''"Start"''' row to make our start point the center of the locator.

[[File:XYZex2.1.jpg|800px]]


2) In the '''"Bend 1"''' row enter '''"12"''' for '''"X"''', and '''"0"''' for both '''"Y"''' and '''"Z"'''. - This will give us 12" from the start of the tube, to the apex of the bend.

[[File:XYZex2.2.jpg|800px]]


3) In the '''"'End"''' row enter '''"27"''' for''' "X"''', '''"15'''" for '''"Y"''', and '''"0"''' for '''"Z"'''. - From the apex of the bend, this will put our third point +15 down the X axis and +15 down the Y axis.

[[File:XYZex2.3.jpg|800px]]