Fabcam1 at 16:28, 4 June 2014

2014-06-04T16:28:23Z

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Single Part -Interface/General Functions :: Bump Bending''' right The bump bending plug-in allows bend..."

2014-06-04T16:23:22Z

Created page with "'''Bend-Tech 7x Wiki :: Single Part -Interface/General Functions :: Bump Bending''' right The bump bending plug-in allows bend..."

New page

'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Single Part -Interface/General Functions]] :: Bump Bending'''

[[File:single_part_15.png|right]]

The bump bending plug-in allows bends to be sectioned off into multiple smaller, equal sized bends. When adding a series of bump bends to a bend, a die is chosen along with the bend and the number of bump bends that will be used to create the full bend. This is typically used with bends that have very large radii. This function helps break these kind of bends down into more manageable bends.

In the example to the right, a '''90°''' bend with a CLR of '''10 inches''' is slop into five '''18°''' bump bends with '''3 inch''' CLRs.

'''To use the bump bend plug-in''', first design the part normally. The part needs to be designed before the bump bends are added. Design the bends that will be sectioned off into smaller bends normally by applying a die to the bend or by giving it a custom CLR.

Once the part design is complete (or at least the bend that will have the bump bends added to it is complete) , click the ''Bump Bending''' button located in the '''[[Single Part -Interface/General Functions#Tasks|Tasks]]''' tab in the part designer.

@@ Line 9: / Line 9: @@
 In the example to the right, a '''90°''' bend with a CLR of '''10 inches''' is slop into five '''18°''' bump bends with '''3 inch''' CLRs.
-'''To use the bump bend plug-in''', first design the part normally. The part needs to be designed before the bump bends are added. Design the bends that will be sectioned off into smaller bends normally by applying a die to the bend or by giving it a custom CLR.
+A message box will open where the die, bend, and number of bump bends can be chosen.
-Once the part design is complete (or at least the bend that will have the bump bends added to it is complete) , click the ''Bump Bending''' button located in the '''[[Single Part -Interface/General Functions#Tasks|Tasks]]''' tab in the part designer.
+The bump bends will be added to the part and generated in the entry fields and the results table at the top.

Bump Bending - Revision history

Fabcam1 at 16:28, 4 June 2014

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Single Part -Interface/General Functions :: Bump Bending''' right The bump bending plug-in allows bend..."