Creating a Double-Beveled Hoop Using Mirroring - Revision history

Fabcam1 at 15:14, 27 June 2014

2014-06-27T15:14:38Z

Fabcam1 at 21:46, 9 June 2014

2014-06-09T21:46:01Z

Fabcam1 at 20:39, 5 June 2014

2014-06-05T20:39:35Z

Fabcam1: Created page with "In this section, we will show you how to create a double-beveled hoop using the mirroring feature in the xyz interface. NOTE: All XYZ locations are based upon a 0,0,0 global ..."

2014-06-05T14:40:07Z

Created page with "In this section, we will show you how to create a double-beveled hoop using the mirroring feature in the xyz interface. NOTE: All XYZ locations are based upon a 0,0,0 global ..."

New page

In this section, we will show you how to create a double-beveled hoop using the mirroring feature in the xyz interface.

NOTE: All XYZ locations are based upon a 0,0,0 global location. Which means that each location is referenced to an absolute location. The start point does NOT need to be 0,0,0.

1) First, change the "Number of Bends" to "4" and zero out the "Start" column.

Hoop1.png

2) You will need to enter a value for the bend past the middle of the part (in this case, bend #3) in order to be able to mirror. Enter the following values:

Hoop2.png

3) Click the "Mirror X" button and Bend-Tech will fill in the remaining values in order to mirror the first half of the part to the second half.

Hoop3.png

@@ Line 5: / Line 5: @@
 ) First, change the '''"Number of Bends"''' to '''"4"''' and zero out the '''"Start"''' column.
-[[File:Hoop1.jpg]]
+[[File:Hoop1.jpg|700px]]
 ) You will need to enter a value for the bend past the middle of the part (in this case, bend #3) in order to be able to mirror. Enter the following values:
-[[File:Hoop2.jpg]]
+[[File:Hoop2.jpg|700px]]
 ) Click the "Mirror X" button and Bend-Tech will fill in the remaining values in order to mirror the first half of the part to the second half.
-[[File:Hoop3.jpg]]
+[[File:Hoop3.jpg|700px]]

@@ Line 1: / Line 1: @@
 In this section, we will show you how to create a double-beveled hoop using the mirroring feature in the xyz interface.
-NOTE: All XYZ locations are based upon a 0,0,0 global location. Which means that each location is referenced to an absolute location. The start point does NOT need to be 0,0,0.
+'''NOTE: All XYZ locations are based upon a 0,0,0 global location. Which means that each location is referenced to an absolute location. The start point does NOT need to be 0,0,0.'''
-) First, change the "Number of Bends" to "4" and zero out the "Start" column.
+) First, change the '''"Number of Bends"''' to '''"4"''' and zero out the '''"Start"''' column.
 Hoop1.png