Difference between revisions of "Decimal & Fraction"
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | The " | + | The '''"Lengths"''' drop down menu under the '''"LRA/Part Settings"''' button is used to format the resulting '''"lengths"''' or '''"locations"''' and the part's '''"cut length"'''. It is located in the '''"Output Results"''' tab. |
If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set the tolerance to 2 or 3 decimal places. | If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set the tolerance to 2 or 3 decimal places. | ||
| Line 6: | Line 6: | ||
| − | Make sure to change values in the Options menu which can be accessed by clicking the "Tools" menu and selecting "Options". The Decimal/Fraction adjustment menu can be found in the "General" tab, in the Tolerance section under "Lengths". | + | Make sure to change values in the Options menu which can be accessed by clicking the '''"Tools"''' menu and selecting '''"Options"'''. The Decimal/Fraction adjustment menu can be found in the '''"General"''' tab, in the Tolerance section under '''"Lengths"'''. |
[[File:DecimalFraction2.png]] | [[File:DecimalFraction2.png]] | ||
Latest revision as of 13:54, 5 October 2015
The "Lengths" drop down menu under the "LRA/Part Settings" button is used to format the resulting "lengths" or "locations" and the part's "cut length". It is located in the "Output Results" tab.
If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set the tolerance to 2 or 3 decimal places.
Make sure to change values in the Options menu which can be accessed by clicking the "Tools" menu and selecting "Options". The Decimal/Fraction adjustment menu can be found in the "General" tab, in the Tolerance section under "Lengths".
