Difference between revisions of "Creating an Angle Dimension"
(Created page with "Creating an angle dimension requires a little more finesse than defining a simple horizontal or vertical dimension. NOTE: In some cases you may need to create an additional P...") |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
NOTE: In some cases you may need to create an additional PickPoint to have the number of points required. | NOTE: In some cases you may need to create an additional PickPoint to have the number of points required. | ||
| − | To create an angle dimension you need to pick | + | To create an angle dimension you need to pick the two lines that represent the angle. The order of the selections is outside-in for each line. |
| − | Select the "Angle Dim" command button. | + | Select the '''"Angle Dim"''' command button. |
| − | Select the " | + | Select the '''"Lines"''' in the order shown. Line one, outside-in. Line two, outside-in. |
| − | AngleDim1.png | + | [[File:AngleDim1.png]] |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Latest revision as of 12:16, 30 September 2015
Creating an angle dimension requires a little more finesse than defining a simple horizontal or vertical dimension.
NOTE: In some cases you may need to create an additional PickPoint to have the number of points required.
To create an angle dimension you need to pick the two lines that represent the angle. The order of the selections is outside-in for each line.
Select the "Angle Dim" command button.
Select the "Lines" in the order shown. Line one, outside-in. Line two, outside-in.
