Difference between revisions of "Create a Bent Part"

From Bend-Tech 7x Wiki
Jump to: navigation, search
Line 4: Line 4:
 
Please review the following thread:
 
Please review the following thread:
 
http://www.bend-tech.com/wiki7/index.php?title=Assembly#Bent
 
http://www.bend-tech.com/wiki7/index.php?title=Assembly#Bent
 
&
 
 
The rules for Custom 3D are also important to understand:
 
http://www.2020softwaresolutions.com...hread.php?t=48
 
 
  
  

Revision as of 09:19, 30 September 2015

This thread will show how to create a "Bend Part" (a part with bends) in the assembly interface.

Please review the following thread: http://www.bend-tech.com/wiki7/index.php?title=Assembly#Bent


Step 1: Select the command button "Bent Part"

Bent1.jpg


Step 2: Enter the number of bends and "OK" to continue.

Bent2.jpg


Step 3: Select the first "PickPoint" of the part. This is one end of the part. The part creation is now tied to the cursor.

Step 4: Select the "PickPoint" for the apex of 1st bend.

Step 5: Select the "PickPoint"s for any additional bends in the part. Pick these in order.

Step 6: Select the "PickPoint" for the end of the part.

Bent3.jpg


Step 7: Enter in a "Part Name". Select "OK" to continue

Bent4.jpg


Notice how Bend-Tech will update the part with the material and tooling that is selected. The PickPoints for the part features are automatically generated.

Bent5.jpg