Difference between revisions of "Dragon Calibration"
| Line 1: | Line 1: | ||
| − | '''"This guide will help you understand all of the processes and procedures involved in calibrating your Dragon Software to your machine."''' | + | '''"This guide will help you understand all of the processes and procedures involved in assembling your Dragon Machine and calibrating your Dragon Software to your machine."''' |
| − | '''"Please take your time in calibrating your new Dragon Software by following all of these steps thoroughly. This should take anywhere from | + | '''"Please take your time in assembling and calibrating your new Dragon Machine/Software by following all of these steps thoroughly. This should take anywhere from 2-3 hours based on how you pay attention to detail, how much help you have and if you are technologically adept or not."''' |
'''"Each step will have a short video attached to it showing how that particular step is meant to be completed by the operator."''' | '''"Each step will have a short video attached to it showing how that particular step is meant to be completed by the operator."''' | ||
| Line 42: | Line 42: | ||
*The '''"Basic Assembly"''' page will allow you to watch a video of the machine being assembled and will also contain a link that will allow you to print out step by step instructions on how to assemble it. | *The '''"Basic Assembly"''' page will allow you to watch a video of the machine being assembled and will also contain a link that will allow you to print out step by step instructions on how to assemble it. | ||
| − | + | *A copy of the instructions for assembly can be found [['''here'''] | |
| − | |||
| − | |||
Revision as of 13:50, 27 October 2015
"This guide will help you understand all of the processes and procedures involved in assembling your Dragon Machine and calibrating your Dragon Software to your machine."
"Please take your time in assembling and calibrating your new Dragon Machine/Software by following all of these steps thoroughly. This should take anywhere from 2-3 hours based on how you pay attention to detail, how much help you have and if you are technologically adept or not."
"Each step will have a short video attached to it showing how that particular step is meant to be completed by the operator."
Contents
Introduction
- This introduction gives you a small insight into the tasks that are expected during this calibration and reminds you that you will click the "Next" button after each step has been completed.
- You may also click the "Back" button if you have skipped a step accidentally or if you have to revise a step in any way.
Basic Assembly
- The "Basic Assembly" page will allow you to watch a video of the machine being assembled and will also contain a link that will allow you to print out step by step instructions on how to assemble it.
- A copy of the instructions for assembly can be found [[here]
Electrical Connections
- This page will explain and show video of how "Electrical Connections" are set up and the locations of each connection that needs to be made before calibration and operation of the machine.
Power on Machine
- This page will indicate the Two power switches that must be turned on in order to run the machine and it will prompt you to open the "Mach 3" software program.
X-Axis Movement: Chuck Travel
