Difference between revisions of "Creating an Angle Dimension"
| Line 9: | Line 9: | ||
Select the '''"PickPoints"''' in the order shown. Line one, outside-in. Line two, outside-in. | Select the '''"PickPoints"''' in the order shown. Line one, outside-in. Line two, outside-in. | ||
| − | AngleDim1. | + | [[File:AngleDim1.jpg]] |
'''Select a screen location with your cursor.''' NOTE: not a PickPoint for this selection. | '''Select a screen location with your cursor.''' NOTE: not a PickPoint for this selection. | ||
| − | AngleDim2. | + | [[FIle:AngleDim2.jpg]] |
This next picture will be the end result: | This next picture will be the end result: | ||
| − | AngleDim3. | + | [[File:AngleDim3.jpg]] |
Revision as of 13:58, 9 June 2014
Creating an angle dimension requires a little more finesse than defining a simple horizontal or vertical dimension.
NOTE: In some cases you may need to create an additional PickPoint to have the number of points required.
To create an angle dimension you need to pick both ends of the line that represents the angle. The order of the selections is outside-in for each line.
Select the "Angle Dim" command button.
Select the "PickPoints" in the order shown. Line one, outside-in. Line two, outside-in.
Select a screen location with your cursor. NOTE: not a PickPoint for this selection.
This next picture will be the end result:
