Difference between revisions of "Values (Arc)"

From Bend-Tech 7x Wiki
Jump to: navigation, search
(Created page with "thumb|0° is to the right, rather than up. == Description == Creates an arc based on start angle, end angle, and radius. == How-To == Input the rad...")
(No difference)

Revision as of 12:49, 6 June 2014

File:CADdegrees.PNG
0° is to the right, rather than up.

Description

Creates an arc based on start angle, end angle, and radius.

How-To

Input the radius, start angle, and end angle of the arc into their respective fields. Click on a point to place the arc with its center directly over that point. Check the Full Circle checkbox to automatically set the start angle at 0 and the end angle at 360, creating a full circle.