Difference between revisions of "Creating an Angle Dimension"

Revision as of 13:02, 25 June 2014

Creating an angle dimension requires a little more finesse than defining a simple horizontal or vertical dimension.

NOTE: In some cases you may need to create an additional PickPoint to have the number of points required.

To create an angle dimension you need to pick the two lines that represent the angle. The order of the selections is outside-in for each line.

Select the "Angle Dim" command button.

Select the "Lines" in the order shown. Line one, outside-in. Line two, outside-in.

Select a screen location with your cursor. NOTE: not a PickPoint for this selection.

This next picture will be the end result:

@@ Line 3: / Line 3: @@
 NOTE: In some cases you may need to create an additional PickPoint to have the number of points required.
-To create an angle dimension you need to pick both ends of the line that represents the angle. The order of the selections is outside-in for each line.
+To create an angle dimension you need to pick the two lines that represent the angle. The order of the selections is outside-in for each line.
 Select the '''"Angle Dim"''' command button.
-Select the '''"PickPoints"''' in the order shown. Line one, outside-in. Line two, outside-in.
+Select the '''"Lines"''' in the order shown. Line one, outside-in. Line two, outside-in.
 [[File:AngleDim1.jpg]]