Difference between revisions of "Dragon Straight Part Tutorial"
| Line 11: | Line 11: | ||
3. Next, select the '''Tube Length''' value field [[File:Tube_Length1.png]] and enter the number '''24'''. The straight tube should appear below in the display area. | 3. Next, select the '''Tube Length''' value field [[File:Tube_Length1.png]] and enter the number '''24'''. The straight tube should appear below in the display area. | ||
| + | |||
[[File:Straight_24_In_Tube.png]] | [[File:Straight_24_In_Tube.png]] | ||
4. From here, check both '''Display Cross Tube''' [[File:Dragon_Display Cross_Tube1.png]] checkboxes on either side of the '''Tube Length''' value field. | 4. From here, check both '''Display Cross Tube''' [[File:Dragon_Display Cross_Tube1.png]] checkboxes on either side of the '''Tube Length''' value field. | ||
| + | |||
[[File:Straight_24_Cross_Tubes_Attached.png]] | [[File:Straight_24_Cross_Tubes_Attached.png]] | ||
| − | 5. Now, type in '''110''' into both '''Angle''' value fields. This will adjust the angle of the copes as shown in the display area. | + | 5. Now, type in '''110''' into both '''Angle''' [[File:Drag-Angles1.png]] value fields. This will adjust the angle of the copes as shown in the display area. |
| + | |||
[[File:Straight_24_Angles_Attached.png]] | [[File:Straight_24_Angles_Attached.png]] | ||
| + | |||
| + | 6. | ||
Revision as of 15:17, 18 January 2016
Dragon Straight Part Tutorial 
Things To Know
- This tutorial will step you through the process of creating a straight design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.
Tutorial
1. From the Bend-Tech Dragon start up screen, click on the Straight .png)
button to open the straight part interface.
2. Now, maximize the screen 
.
3. Next, select the Tube Length value field 
and enter the number 24. The straight tube should appear below in the display area.
4. From here, check both Display Cross Tube 
checkboxes on either side of the Tube Length value field.
5. Now, type in 110 into both Angle 
value fields. This will adjust the angle of the copes as shown in the display area.
6.
