Difference between revisions of "My Material or Tooling Library won't Update"
(Created page with "My material or tooling library won't update. This is a common question and here is a list as to the reasons why: --> You must select the "Add New" button before entering the...") |
|||
| Line 5: | Line 5: | ||
--> You must select the "Add New" button before entering the tooling or material information. | --> You must select the "Add New" button before entering the tooling or material information. | ||
| − | When you enter in the material diameter or wall thickness, or the tooling clr, calibrated clr or bend location offset you MUST | + | *When you enter in the material diameter or wall thickness, or the tooling clr, calibrated clr or bend location offset you MUST |
| − | Use a decimal place number. | + | *Use a decimal place number. |
| − | No other characters like " or ' also do not use text like inch or mm | + | *No other characters like " or ' also do not use text like inch or mm |
| − | The material diameter must be greater than twice the wall thickness. many times a user will put in .95 instead of .095 | + | *The material diameter must be greater than twice the wall thickness. many times a user will put in .95 instead of .095 |
| − | In the material library the dimension under the "circle" is the OD of material. | + | *In the material library the dimension under the "circle" is the OD of material. |
--> It is okay to leave the weight in the material library as 0 | --> It is okay to leave the weight in the material library as 0 | ||
| Line 15: | Line 15: | ||
--> When finished select the "Apply" button. This will update the list on the left hand side. | --> When finished select the "Apply" button. This will update the list on the left hand side. | ||
| − | --> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. SELECT THE "OK" BUTTON WHEN FINISHED. | + | --> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. '''SELECT THE "OK" BUTTON WHEN FINISHED.''' |
Revision as of 13:17, 5 June 2014
My material or tooling library won't update.
This is a common question and here is a list as to the reasons why:
--> You must select the "Add New" button before entering the tooling or material information.
*When you enter in the material diameter or wall thickness, or the tooling clr, calibrated clr or bend location offset you MUST *Use a decimal place number. *No other characters like " or ' also do not use text like inch or mm *The material diameter must be greater than twice the wall thickness. many times a user will put in .95 instead of .095 *In the material library the dimension under the "circle" is the OD of material.
--> It is okay to leave the weight in the material library as 0
--> When finished select the "Apply" button. This will update the list on the left hand side.
--> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. SELECT THE "OK" BUTTON WHEN FINISHED.
