Difference between revisions of "What is Calibrated CLR?"
(Created page with "This is the center line radius that is the mathematical radius for determining material growth through the bend Finding your Calibrated Centerline Radius To find the Calibr...") |
|||
| Line 2: | Line 2: | ||
| − | Finding your Calibrated Centerline Radius | + | '''Finding your Calibrated Centerline Radius''' |
To find the Calibrated CLR use the following procedure: | To find the Calibrated CLR use the following procedure: | ||
| Line 20: | Line 20: | ||
Formula: Calibrated CLR = ( leg1 + leg2 - cut length - OD) * 2.33 | Formula: Calibrated CLR = ( leg1 + leg2 - cut length - OD) * 2.33 | ||
| − | Note: You should find the Calibrated CLR to be 5 to 20% larger than the labeled CLR on your die. | + | '''Note: You should find the Calibrated CLR to be 5 to 20% larger than the labeled CLR on your die.''' |
Revision as of 14:04, 5 June 2014
This is the center line radius that is the mathematical radius for determining material growth through the bend
Finding your Calibrated Centerline Radius
To find the Calibrated CLR use the following procedure:
Cut a piece of tube and measure it after the cut (cut length).
CCLR1.gif
Bend it to 90 degrees such that the bend is 90 degrees after bending. The location of the bend is not needed for this formula, so you may bend it anywhere as long as there is enough material to properly go through your bender.
CCLR2.gif
The OD is the outside tube diameter.
Formula: Calibrated CLR = ( leg1 + leg2 - cut length - OD) * 2.33
Note: You should find the Calibrated CLR to be 5 to 20% larger than the labeled CLR on your die.
