Difference between revisions of "Basic Computer Requirements/Information"
BT-JAnderson (talk | contribs) (→Bend-Tech 7x Minimum Computer Requirements List) |
BT-JAnderson (talk | contribs) (→Running Bend-Tech 7x on a MAC OS) |
||
| Line 73: | Line 73: | ||
*Misc 110-120v Outlets (computer, monitor, etc) | *Misc 110-120v Outlets (computer, monitor, etc) | ||
| − | == | + | ==Does Bend-Tech run on a MAC computer?== |
| − | Bend-Tech | + | Bend-Tech software does NOT run on MAC computers. |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
==What If I Have a Surface Computer? Tablet?== | ==What If I Have a Surface Computer? Tablet?== | ||
Revision as of 14:16, 21 March 2023
Contents
Bend-Tech 7x Minimum Computer Requirements List
Minimum Requirements
- Windows Operating System (7, 8, 8.1, 10). Bend-Tech software does NOT run on MAC.
- 1 GHz Processor
- 2 GB of RAM (4 GB or more recommended)
- 2 GB of hard drive free
- 1024x768 graphics resolution
- OpenGL 1.3 Compatible Graphics Card
- .NET framework 3.5 installed.
- Mouse/Keyboard
- Active Internet Connection (except when using a dongle) NOTE: Internet Connection is needed during the first activation and then every 6 months, the software can run offline in between.)
Bend-Tech Dragon: Required Components
Minimum Computer Requirements
- Windows Operating System 7, 8, 8.1, 10.
- 2.0 GHz Dual-Core Processor
- 4 GB Ram (Memory)
- 2 GB Free Hard Drive Space
- 1280 x 800 Screen Resolution or greater
- OpenGL 1.3 Compatible Graphics Adapter
- .NET Framework 3.5 SP1 Installed
- Dedicated Ethernet port (for running machine)
- Wifi Adapter or secondary Ethernet port (internet is required)
- Full Keyboard and Mouse
- NOTE: Your dedicated PC/Laptop must have internet connectivity either by wifi or direct connection to a router via a second ethernet port (aside from the ethernet port dedicated for use with the Dragon machine).
Without internet connectivity, your Bend-Tech support will be severely limited.
Plasma Torch Requirements
- Hypertherm Powermax Series (45, 45XP, 65, 85)
- Mechanized Torch Head
Air Requirements
- Air Compressor (Engraver and Center Gate/Lifter)
- Air Compressor or Inert Gas (for Plasma Cutting) - (Min 6 cfm @ 90psi)
- Air Filter and/or Dryer may be required depending upon your environment
Electrical Requirements
- 220-240v Outlet (for plasma system - see owner's manual for more information)
- 2x - 110-120v 15Amp Outlets (A150 machine)
- 1x - 110-120v 20Amp Outlet (A400 machine)
- Misc 110-120v Outlets (computer, monitor, etc)
Does Bend-Tech run on a MAC computer?
Bend-Tech software does NOT run on MAC computers.
What If I Have a Surface Computer? Tablet?
Bend-Tech 7x works on a few Surface laptops, but not all. And it is NOT setup for use on a tablet or other mobile devices.
See our diagram below.
