My Bent Part Doesn't Follow my PickPoints

From Bend-Tech 7x Wiki
Revision as of 14:57, 4 June 2014 by Fabcam1 (talk | contribs) (Created page with "My bent part doesn't follow my PickPoints. This issue comes up on occasion, typically from new users. The cause: (case 1) You have a bend angle of 0 degrees. This is caused ...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

My bent part doesn't follow my PickPoints.

This issue comes up on occasion, typically from new users.

The cause: (case 1) You have a bend angle of 0 degrees. This is caused by 3 points being in a line and the software can not create an arc because there is no change in direction from the center point.


The cause: (case 2) Typically this is caused from not enough distance between PickPoints to allow for the radius of your tooling.

As an example; If you are making a 2 bend "U" bracket with the 2 bends of 90 degrees than the distance between the 2 dots must be at least 2 times your CLR.

Retrieved from "http://www.bend-tech.net/wiki7/index.php?title=My_Bent_Part_Doesn%27t_Follow_my_PickPoints&oldid=615"