Lines

Bend-Tech 7x Wiki :: Assembly :: PickPoints :: Lines

Line (Two Points)

Creates a PickPoint that is aligned between two other PickPoints.

Click the Set Reference button and click two PickPoints.

In the Move Amount field, enter the distance from the first PickPoint that the new PickPoint should be. To measure the Move Amount distance from the other point, click the Swap Ends button. To set the new point directly in between the reference points click the Split in Half button.

To place the point, click the Apply button.

Intersection

Creates a point at the intersection of two user defined lines.

Click the Set Reference button and click the start point and end point of the first line. Click the start and end point of the second line. Check the Closest Intersection

Click the Apply' button to place a PickPoint at the intersection of the two lines.