PickPoints - 2 Points

The PickPoint - 2 Points method allows for a point to be located "x" number of millimeters or inches down a line.

Step 1: Select the "PickPoints" tab, then the "Reference" tab.

Step 2: Select the "Set Reference" command button under Two Points.

Step 3: Select a "PickPoint" for the start end of the line. Note: The distance value will be determined from this end.

Step 4: Select the 2nd "PickPoint" representing the line.

Step 5: Enter the value into the "Move Amount" field. You will see a Purple point at this location.

Step 6: Select the "Apply" command.