Move NRC

From Bend-Tech 7x Wiki
Revision as of 13:37, 27 May 2016 by Fabcam1 (talk | contribs)
Jump to: navigation, search
Dragon NRC Move2.png

Material Thickness at:

Dragon NRC Material Thickness At1.png

  • This section will simply display the material thickness at the top and bottom edges of the hole cutout. When the NRC is changed, you will see the top dead center location (indicated by the highlighted and dotted line) in reference to the diameter of tubing that has been applied to the design (indicated by the gray rectangle around the NRC cut.

NRC Cut TDC1.pngFile:NRC Highlighted Tube Representation1.png

Y Center Offset:

Retrieved from "http://www.bend-tech.net/wiki7/index.php?title=Move_NRC&oldid=7538"