Values (Arc)

From Bend-Tech 7x Wiki
Revision as of 13:50, 6 June 2014 by Fabcam1 (talk | contribs)
Jump to: navigation, search
0° is to the right, rather than up.

Description

Creates an arc based on start angle, end angle, and radius.

How-To

Input the radius, start angle, and end angle of the arc into their respective fields. Click on a point to place the arc with its center directly over that point. Check the Full Circle checkbox to automatically set the start angle at 0 and the end angle at 360, creating a full circle.